Measure - Pentax R-422VN Instruction Manual

4. MEASURE

3.Rotated plane
Offset
Reference P. Coordinates
1.Cylinder face
Remote
2.Fixed plane
Backsight P. Coordinates
Azimuth
Station Point Coordinates
An operator can measure the Foresight Point Coordinates from the "Station Point Coordinates
and Backsight Coordinates" or the "Station Point Coordinates and Azimuth", and can store
the Point Name and measured Coordinates in the memory. When the Coordinates of the
Station Point and Backsight Point are already stored in the memory, the new Coordinates
input can be omitted by calling or searching from the Point Name LIST.
The Point Name is within 15 characters and the Coordinates are within 8 in integer and 3 in
decimal number. There are two Coordinates types: Rectangular and Polar Coordinates in this
[MEASURE].
The Offset at the Target Point Measurement is possible and the Remote Measurement, by
aiming at any point, is possible as well when you select the Rectangular Coordinates.
An operator can perform the [MEASURE] function only when the Telescope is at the "Face
left position".
Select the Target type before performing the [MEASURE].
After measuring rectangular coordinates by [MEASURE] function of PowerTopoLite, it is
possible to display Angle and Distance by switching the [F3][ANG&DIST] key.
When Remote Mode is selected, Angle and Distance are also calculated according to the
Coordinates of the Aiming Point on real time.
When offset mode is selected, Angle and Distance are also calculated according to the
Coordinates where offset value is added.
18