Import Procedure
Press [F3] [I/O] on PowerTopoLite screen to
display TRANSFER MENU.
[In case of using file conversion]
First, set "PointCodeList.csv" in the instrument by means of USB or SD card.
Then, specify ExtCSV to format and carry out file conversion.
More details on file conversion, refer to "12.1.2 Reading from Text File".
[In case of using COM port]
In case of using COM port, communication setting is necessary.
Press [F3] [COM] to display TRANSFER screen.
To check the communication setting, select
"4. COMMUNICATION SETUP" in the
TRANSFER screen and press [ENT] to view
COMM.SETTING SELECTION screen.
Then select "1. RECEIVE RECT.DATA" and set "1. BAUD RATE" to "1200",
"6. XON/XOFF" to "OFF" for using "DL-01", "ON" for using "HYPER TERMINAL".
"7. PROTOCOL" to "OFF" "8. RECORD DELIMITER" to "CR+LF" and press [ACCEPT].
( Cfr. "12.3.3.1 Receiving data setting")
After the communication setting, specify ExtCSV
for format, then start transfer.
For more details on the procedure, refer to "12.3.1
Input from the PC"
5.4.2 PointCode Create
Press [ENT] to view the PointCode Create screen.
Press [ENT] to view and input the PC.
After input, press [F1] [SAVE] to save the values.
43