Table of Contents
Advertisement
8.5 Entering the mode for initial setting 5
Press the [POWER] key while holding [F5] key
down to access the screen for initial setting 5.
• Select the item of interest in the same way as
in the mode for initial setting 5.
8.6 Entering the mode for setting of date and time
Press the [POWER] key while holding [F3]+[F4]
key down to access the screen for Date･Time Input.
8.7 Example of changing an initial setting content
(selection of atmospheric correction)
This section describes the operating procedures for selecting "1.ATM CORR" in initial
setting 1 as an example of changing an initial setting content. Use this example as a reference
when changing other items because it is also applicable to the operating procedures for
changing them.
Access the screen for initial setting 1 by taking
procedures "8.2 Enter the mode for initial setting 1".
Press [F5][SELECT] to open the screen for selecting
the atmospheric correction.
Press [F3][
] or [F4][
] to position the cursor at
the desired item, then press [ENT] key to select that
item.
Pressing the [ENT] key selects the change of
selected item. Pressing the [ESC] key invalidates the
change of selected item.
42
Advertisement
Table of Contents
