Turntable Rotation Components; Turntable Rotation Hydraulic Motor And Drive Hub - Genie S-100 Service And Repair Manual

March 2017
12-1
Turntable Rotation Hydraulic
Motor and Drive Hub
How to Remove the Turntable
Rotation Hydraulic Motor
Note: When removing a hose assembly or fitting,
the O-ring on the fitting and/or hose end must be
replaced and then torqued to specification during
installation. Refer to Specifications, Hydraulic
Hose and Fitting Torque Specifications.
1 Secure the turntable from rotating with the
turntable rotation lock pin.
unlocked
2 Remove the ground controls side fixed turntable
cover. See 5-1, How to Remove a Fixed
Turntable Cover.
Part No. 1268494

Turntable Rotation Components

locked
S-100 • S-105 • S-120 • S-125
Section 3 • Repair Procedures
3 Tag, disconnect and plug the hydraulic hoses
from the manifold that is mounted to the motor.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to squirt
or spray.
4 Remove the motor/brake mounting fasteners.
Remove the motor from the brake.
a motor
b motor/brake mounting bolts
c brake
d drive hub mounting bolts
e drive hub
a
e
d
3 - 129
b
c