Membrane Decal - Genie S-100 Service And Repair Manual

Section 3 • Repair Procedures
PLATFORM CONTROLS
3 Locate the membrane circuit board mounted to
the inside of the platform control box lid.
Electrocution/burn hazard. Contact
with electrically charged circuits
could result in death or serious
injury. Remove all rings, watches
and other jewelry.
Note: Component damage hazard. Electrostatic
discharge (ESD) can damage printed circuit board
components. Maintain firm contact with a metal
part of the machine that is grounded at all times
when handling printed circuit boards OR use a
grounded wrist strap.
4 Carefully disconnect the two ribbon cables from
the membrane circuit board.
5 Remove the membrane circuit board retaining
fasteners.
6 Carefully remove the membrane circuit board
from the platform control box lid.
3 - 8
1-2

Membrane Decal

How to Replace the Membrane
Decal
The membrane decal is a special decal that
consists of a decal with an electronic membrane
on the backside. The membrane contains touch
sensitive areas that, when pushed, activates the
machine functions. The membrane buttons activate
machine functions similar to toggle switches, but
do not have any moving parts.
1 Push in the Emergency Stop button to the
off
controls.
2 Remove the platform control box lid retaining
fasteners. Open the control box lid.
3 Carefully disconnect the two ribbon cables from
the membrane circuit board.
Note: Component damage hazard. Electrostatic
discharge (ESD) can damage printed circuit board
components. Maintain firm contact with a metal
part of the machine that is grounded at all times
when handling printed circuit boards OR use a
grounded wrist strap.
S-100 • S-105 • S-120 • S-125
position at both the ground and platform
Electrocution/burn hazard. Contact
with electrically charged circuits
could result in death or serious
injury. Remove all rings, watches
and other jewelry.
March 2017
REV B
Part No. 1268494