Jib Boom Components, S-105 And S-125 Models - Genie S-100 Service And Repair Manual

March 2017
12 Remove the pin retaining fasteners from the
jib boom lift cylinder rod-end pivot pin. Do not
remove the pin.
13 Slide both of the jib boom leveling arms off of
the jib boom pivot pin and lay them off to the
side.
14 Attach a lifting strap from an overhead crane
to the lug on the rod end of the jib boom lift
cylinder.
15 Use a soft metal drift to remove the jib boom
lift cylinder rod-end pivot pin. Remove the jib
boom lift cylinder from the jib boom bellcrank.
Crushing hazard. The jib boom lift
cylinder may become unbalanced
and fall when it is removed from
the machine if it is not properly
supported.
16 Attach a lifting strap from an overhead crane to
the jib boom bellcrank.
17 Support the rod end of the platform leveling
cylinder with a suitable lifting device. Protect
the cylinder rod from damage.
Part No. 1268494

JIB BOOM COMPONENTS, S-105 AND S-125 MODELS

18 Remove the pin retaining fastener from the
platform leveling cylinder rod-end pivot pin.
19 Use a soft metal drift to remove the platform
leveling cylinder rod-end pivot pin.
20 Remove the pin retaining fastener from the jib
boom bellcrank pivot pin.
21 Use a soft metal drift to remove the jib boom
bellcrank pivot pin. Remove the jib boom
bellcrank from the machine.
S-100 • S-105 • S-120 • S-125
Section 3 • Repair Procedures
Crushing hazard. The platform
leveling cylinder may fall if it is not
properly supported when the rod-
end pivot pin is removed.
Crushing hazard. The jib boom
bellcrank may fall if it is not
properly supported when the
platform leveling cylinder rod-end
pivot pin is removed.
Crushing hazard. The jib boom
bellcrank may become unbalanced
and fall if it is not properly
supported when it is removed from
the machine.
3 - 27