Control System Fault Codes - Genie S-100 Service And Repair Manual

March 2017
P_38-Propel P_39-Turntable
(P13-17 TCON) Rotate (P13-19
P_22-Jib Jib P_22R - Primary
Lvl Pwr Up/Down FC
Turntable tilt axis (+5°, secondary
boom not stowed)
Primary Boom Angle (crosscheck)
Primary Boom Length (crosscheck)
Primary 2 Cylinder (crosscheck)
Boom Envelope Safety Interlock
Axle Safety Not Stowed
Axles crosscheck Angle sensor vs.
safety switch(es)
Axle (not fully extended) and TT
Rotate (stowed and in drive disable
zone)
Turntable Tilt Angle (crosscheck
SCON internal sensor 3 in a delta
configuration)
Loss of CAN
Platform Overload (SCON pin #1)
Platform Out of Level (>10°)
Jib Bellcrank Out of Level (>10°)
Boom Safety (max angle)
Boom Safety (max length)
Axle Retract Safety
Cable Tension (#1 or #2)
* P-9A and P-10 energized if boom is fully retracted as indicated by LSB3RS
Part No. 1268494
P_10-Primary
Boom Extend
TCON) (P12-08 TCON)
P_12 - Axle
Retract (P121-08
SCON)
P_38 P_39
OFF OFF
OFF OFF
OFF OFF
OFF
OFF
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF OFF
S-100 • S-105 • S-120 • S-125

CONTROL SYSTEM FAULT CODES

P_11-Primary
Up (P12-09
TCON)
P_10 P_11 P_9A
OFF
OFF OFF OFF*
OFF OFF OFF*
OFF OFF OFF*
OFF OFF
OFF
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF*
OFF
OFF OFF OFF
OFF
Section 4 • Diagnostic Codes
P_9A-Primary P_9B-
Down (P12-06 Ignition/Fuel
TCON) (P12-07 TCON)
P_9B P_22 P_22R
OFF
OFF
OFF
OFF
OFF
OFF
OFF
P_12
OFF
4 - 9