Platform Controls - Genie S-100 Service And Repair Manual

Section 3 • Repair Procedures

Platform Controls

The platform controls contains two printed circuit
boards:
The membrane circuit board is mounted to the
underside of the control box lid which contains
the LEDs and touch-sensitive buttons for machine
functions. The membrane circuit board sends the
input from the operator to the platform controls
ECM circuit board. The ECM circuit board sends
the data to the turntable control box for processing.
The platform controls ECM circuit board
communicates with the turntable controls. The
joystick controllers at the platform controls utilize
Hall Effect technology and require no adjustment.
The operating parameters of the joysticks are
stored in memory at the turntable controls. If a
joystick controller error occurs or if a joystick is
replaced, it will need to be calibrated before that
particular machine function will operate. See 1-3,
How to Calibrate a Joystick Controller.
Each joystick controller should operate smoothly
and provide proportional speed control over its
entire range of motion.
3 - 6
e
S-100 • S-105 • S-120 • S-125
a b
d
a platform ECM circuit board
b boom extend/retract
joystick controller
c drive/steer joystick controller
d membrane circuit board
e boom up/down and turntable rotate
left/right joystick controller
Part No. 1268494
March 2017
c