Membrane Decal - Genie S-100 Service And Repair Manual

Section 3 • Repair Procedures
GROUND CONTROLS
7 Locate the ECM circuit board mounted to the
inside of the platform control box.
Electrocution/burn hazard. Contact
with electrically charged circuits
could result in death or serious
injury. Remove all rings, watches
and other jewelry.
Component damage hazard.
Electrostatic discharge (ESD)
can damage printed circuit board
components. Maintain firm contact
with a metal part of the machine
that is grounded at all times when
handling printed circuit boards OR
use a grounded wrist strap.
8 Remove the ECM circuit board mounting
fasteners.
9 Carefully remove the ECM circuit board from
the platform control box.
3 - 60
7-2

Membrane Decal

The membrane decal is a special decal that
consists of a decal with an electronic membrane
on the backside. The membrane contains touch
sensitive areas that, when pushed, activates the
machine functions. The membrane buttons activate
machine functions similar to toggle switches, but
do not have any moving parts.
How to Replace the Membrane
Decal
1 Turn the key switch at the ground controls to
the
2 Push in the Emergency Stop button to the
off
controls.
3 Remove the ground control box lid fasteners.
Open the control box lid.
4 Carefully disconnect the two ribbon cables from
the membrane decal at the ECM circuit board.
S-100 • S-105 • S-120 • S-125
position.
off
position at both the ground and platform
Electrocution/burn hazard. Contact
with electrically charged circuits
could result in death or serious
injury. Remove all rings, watches
and other jewelry.
Component damage hazard.
Electrostatic discharge (ESD)
can damage printed circuit board
components. Maintain firm contact
with a metal part of the machine
that is grounded at all times when
handling printed circuit boards OR
use a grounded wrist strap.
March 2017
Part No. 1268494