Platform Overload Recovery Message(Software V3.14 And Later) - Genie S-100 Service And Repair Manual

March 2017
2-6
Platform Overload Recovery
Message (software V3.14 and
later)
If the ground controls LCD screen displays
OVERLOAD RECOVERY, the emergency lowering
system has been used while the platform was
overloaded.
How to Clear the Platform
Overload Recovery Message
Note: This message shall be cleared by a person
trained and qualified on the troubleshooting and
repair of this machine.
Note: Use the following chart to identify the
description of each LCD screen control button
used in this procedure.
Plus Minus
1 Turn the key switch to platform control. Start
the engine and level the platform.
2 Press and hold the enter button on the ground
sontrol panel while turning the key switch to
ground controls. Hold the enter button for
approximately 5 seconds.
Part No. 1268494
Previous Enter
S-100 • S-105 • S-120 • S-125
Section 3 • Repair Procedures
PLATFORM COMPONENTS
3 Press the buttons on the ground
controls in the following sequence:
(plus)(minus)(minus)(plus).
4 Press the enter or previous button on the LCD
screen until CLEAR OVERLOAD RECOVERY
is displayed.
5 Press the plus button or minus
button to select YES. Then press
the buttons in following sequence:
(plus)(plus)(plus)(minus) and press the enter
button to accept.
Note: The passcode buttons
(plus)(plus)(plus)(minus) must be entered in
the proper sequence before the enter button is
pressed.
6 Press the enter or previous button on the LCD
screen until EXIT is displayed.
7 Press the plus button or minus button to select
YES and then press the enter button.
8 Turn the key switch to the off position.
3 - 25