Vital Product Data And Serial Presence Detect Data; Pci Local Bus - Motorola MVME5100 Programmer's Reference Manual

There can be seven slave devices connected to the I
MVME5100. The Vital Product Data (VPD) address shall be $A0. The
User configuration Data (UPD) address shall be $A2.
The on-board MSD address (Memory Bank A and B) shall be $A8. The
optional Memory Mezzanine 1 MSD addresses shall be $AA (Memory
Bank C) and $AC (Memory Bank E) for mezzanine 2.
The IPMC761 VPD address shall be $A4. A digital thermometer
(DS1621) I
Hawk ASIC must be configured at power-up reset time before software
performs any accesses to it. Other configuration information is needed by
software to properly configure the Hawk's control registers. This
information can be obtained from devices connected to the I

Vital Product Data and Serial Presence Detect Data

These registers are partially described in the PowerPlus II Programming
Manual listed in
shall be accessed through the I

PCI Local Bus

The on-board PCI devices on MVME5100 are as follows:
http://www.motorola.com/computer/literature
2
C address shall be $96. Some configuration options in the
Appendix A, Related
The Hawk ASIC
Port 1 and Port 2 Ethernet Controllers
Universe ASIC
PMC Slots
PCI expansion slot
2
C bus on the
Documentation. These registers
2
C interface of the Hawk ASIC.
Hawk ASIC
1
2
C bus.
1-7