V M E P r o c e s s o r M o d u l e s Supercomputing levels of performance in a scalable, single-board computer The MVME5100 is a high-performance VME processor module featuring the Motorola Computer Group (MCG) PowerPlus II architecture with a choice of ® PowerPC processors—either Motorola’s MPC7400 with AltiVec ogy for algorithmic-intensive computations or the low-power MPC750.
MVME761, are individually user-configurable as EIA-232, EIA-530, V.35, or X.21 DCE or DTE via the installation of Motorola Serial Interface Modules (SIMs). A P2 adapter provides interface module signals to the MVME761 transition module. The 3-row P2 adapter can be used for 8-bit SCSI.
face signals to the MVME712M transition module. The 3-row P2 adapter can be used for 8-bit SCSI. To gain access to the additional user definable I/O pins pro- vided via the 5-row VME64 extension connector, a special P2 adapter board is available. This adapter panel replaces the traditional 3-row P2 adapter and extends its capability by pro- viding access to the PMC I/O pins.
PCI Expansion Connector Address/Data: A32/D32/D64 PCI Bus Clock: 33 MHz Signaling: Connector: 114-pin connector located on the planar of the MVME5100 Power Requirements (not including power required by PMC or IMPC modules) +12V MVME5100: 3.0 A typ. 8.0 mA typ. MVME5100 with 3.2 A typ., 0.2 A typ.
Motorola reserves the right to make changes, without notice, to any products or information herein which will, in its sole discretion, improve reliability, function, or design. Motorola does not assume any liability arising out of the application or use of any product or circuit described herein;...