Recoil Starter Installation - Yamaha SRX700D Service Manual

RECOIL STARTER
INSTALLATION
1. Wind:
•
Starter rope (2 1/2 times counterclockwise)
(in the sheave drum)
2. Install:
•
Starter spring 1
•
Sheave drum assembly 2
NOTE:
•
Mesh the spring hook 3 with the case slit, then
wind the spring counterclockwise into the case
from a larger to a smaller diameter.
•
Mesh the sheave drum hook 4 with the spring
SDN5610
hook 5.
3. Install:
•
Drive pawl 1
•
Cam guide 2
•
Drive plate 3
NOTE:
The cam guide 2 should not be on top of the drive
pawl 1.
SDN5620
4. Pull about 102 mm (4 in) of starter rope out of
the cutout portion in the sheave drum and
rotate the sheave drum 4 1/2 times counter-
clockwise to preload the starter spring.
SDN5630
NOTE:
Pass the rope through the case hole and make a
knot 1 in the rope so that the rope is not pulled
into the case.
SDN5640
5-29
ENG