REAR SUSPENSION
Rear suspension-full rate
1. Adjust:
•
Full rate adjuster
Adjustment steps:
Installation
position
Spring rate
and damping
Standard
NOTE:
Be sure to make this adjustment when there is no
SDN2A70
load (rider or cargo) on the snowmobile.
•
Loosen the nut 1 1/2 or 3/4 turns, while hold-
ing the adjusting bolt 2 securely with a wrench
so it does not move.
CAUTION:
Never allow the adjusting bolt 2 to move while
loosening the nut.
SDN2A80
•
Turn the adjusting bolt 2 to the desired posi-
tion.
CAUTION:
Be sure the adjusting bolt ends are set at the
same position on each side.
•
While holding the adjusting bolt securely,
tighten the nut 1.
Nut (full rate adjuster):
SDN2A90
CAUTION:
Never allow the adjusting bolt to move while
tightening the nut.
2-54
INSP
ADJ
A
B
Soft
Medium
B
49 Nm (4.9 m • kg, 35 ft • lb)
C
Hard