Yamaha SRX700D Service Manual page 160

4. Adjust:
•
Skis
Adjustment steps:
•
Temporarily install the handlebar.
•
Hold the handlebar straight and check that the
skis are at right angles to the handlebar.
•
Loosen the locknuts (relay rod) 1.
•
Position the skis parallel in the riding direc-
tion.
•
With the skis in this position, turn the relay rod
2 in either direction until the handlebars at
right angles with respect to the direction of
movement.
Turning the relay rod
in direction a
Turning the relay rod
in direction b
SDN3120
•
Tighten the locknuts (relay rod) 1.
Locknut (relay rod) 1:
5. Install:
•
Handlebar
CAUTION:
•
Be sure the side of the holder with the small
gap a faces forward.
•
Center the match mark b on the handlebar 1
between the lower handlebar holders 2.
SDN3130
Bolt (handlebar holder) 3:
CAUTION:
First tighten the bolts on the front side of the
handlebar holder, and then tighten the bolts
on the rear side.
SDN3140
3-5
CHAS
STEERING
Turning the handlebar
in direction c
Turning the handlebar
in direction d
25 Nm (2.5 m • kg, 18 ft • lb)
®
LOCTITE
15 Nm (1.5 m • kg, 11 ft • lb)