List Of Error Codes Without Messages - Canon IMAGERUNNER 5075 Reference Manual

List of Error Codes without Messages

If a job or operation does not complete successfully, check the error code, and
perform the necessary operations according to the error code displayed. You can
check the error code on the Details screen when you press [Log] on the System
Monitor screen. (See "Job Details," on p. 5-10.)
If a send, receive, or fax job does not complete successfully, the error code is
printed in the Results column on the Activity Report and Send Report. However, if a
send job is canceled, "STOP" is printed in the Results column on the Send Report.
(See Chapter 12, "Printing Communication Reports," in the Sending and Facsimile
Guide.)
Perform the necessary procedures according to the error code.
# 001
Cause 1 Differently sized originals were scanned, and the Different Size Originals mode
was not set.
Remedy Place your originals, specify the Different Size Originals mode, and try scanning
again.
Cause 2 Differently sized originals were scanned in the 2-Sided mode, and the Different
Size Originals mode was not set.
Remedy Place your originals, specify the 2-Sided and Different Size Originals modes,
and try scanning again.
# 009
Cause 1 There is no paper.
Remedy Load paper. (See "Paper Drawers," on p. 7-2.)
Cause 2 The paper drawer is not inserted correctly into the machine.
Remedy Insert the paper drawer properly. (See "Paper Drawers," on p. 7-2.)
# 037
Cause Documents could not be received because there was insufficient memory
available.
Remedy Erase unnecessary documents and documents with errors from memory to
increase the amount of available memory. (See Chapter 2, "Introduction to the
Mail Box Functions," in the Copying and Mail Box Guide, and Chapter 6,
"Receiving Documents," in the Sending and Facsimile Guide.)
List of Error Messages
8
8-87