Specifying The System Manager Settings - Canon IMAGERUNNER 5075 Reference Manual

Specifying the System Manager Settings

You can set an ID and a password for the System Manager. Once the System
Manager ID/password is set, restrictions can be placed on storing or changing the
System Settings.
IMPORTANT
•
Attaching the optional Card Reader-C1 erases the System Manager ID and System
Password that have been stored.
•
Depending on the login service being used, if Department ID Management is set to 'Off'
and a System Manager ID or password is not specified, all users of the machine may be
considered as the Administrator even without authentication.
•
If you are performing user authentication using the SDL or SSO login service, the System
Settings mode is restricted in the following way:
- Users registered as a general user cannot change the System Settings, regardless of
the System Manager ID setting.
- Users registered as an Administrator can change the System Settings by entering the
correct System Manager ID and System Password or registering them in their user data
in advance.
NOTE
•
If the optional Card Reader-C1 is attached, the numbers 1 to 1,000 cannot be used for
the System Manager ID. Numbers 1 to 1,000 are reserved for control cards by default.
•
For instructions on entering characters, see "Entering Characters from the Touch Panel
Display," on p. 2-24.
•
The maximum number of digits that you can store for the System Manager ID and
System Password is seven. If you enter fewer than seven digits for either setting, the
machine stores them with leading zeros.
- Example: If <321> is entered, <0000321> is stored.
1
Press
[System Manager Settings].
(Additional Functions) ➞ [System Settings] ➞

Specifying the System Manager Settings

6
6-3