Bosch D9412GV2 Troubleshooting Manual page 84

D9412GV2/D7412GV2 | Troubleshooting Guide | 3.0
Using a D5200 Programmer
For more information, refer to D5200 Programmer's
Operation and Installation Guide (P/N: 74-06176-000).
1. Using your D5200 Programmer, receive data
from the control panel. Refer to
Receiving Control Panel Programming Using the
D5200 Programmer on page 125.
2. Select PANEL WIDE PARAMETERS and press
[ENTER GROUP].
3. Select Routing and press [ENTER GROUP].
4. In Routing, select R1 Primary Device 1 and
press [1] to set the value to 1.
Press [ENTER] to accept the value
5. Press [EXIT GROUP] once to return to PANEL
WIDE PARAMETER.
6. Select Enhanced Routing and press [ENTER
GROUP].
7. Set RG1 Primary SDI to Yes and press
[ENTER].
8. Send the new record to the control panel. Refer to
Section 4.3.4 Sending Programming Changes to the
Control Panel Using the D5200 Programmer
125.
You can press [SEND (LOAD)] on the
D5200 Programmer at any time.
9. Receive a copy of GV2AUX from the control
panel. Refer to Section 4.3.3 Receiving Control Panel
Programming Using the D5200 Programmer
125.
84
Troubleshooting
10. Select NHANCED COMM and press [ENTER
Section 4.3.3
11.
12. Enter the IP address of the D6600 Receiver in
13.
14. Press [EXIT GROUP] to exit from ENHANCED
15.
16. Set nableAntireplay to Yes by pressing the [Y]
on page
17. Send the new record to the control panel. Refer
on page
E
GROUP].
Set ENHANCED COMM to Yes by pressing [Y].
Press [ENTER].
Path 1 IP Add1 to Path 1 IP Add 4 by pressing
the number keys and [ENTER] after each octet of
the IP address.
Select Path 1Poll Rate and set it to 75, then press
[ENTER].
COMM.
At the NEWRECORD menu, press [↓] repeatedly
to scroll down to MISCELLANEOUS and press
[ENTER GROUP].
E
key. Press [ENTER].
to Section 4.3.4 Sending Programming Changes to the
Control Panel Using the D5200 Programmer
125.
Bosch Security Systems, Inc. | 11/05 | F01U011024B
on page