Bosch D9412GV2 Troubleshooting Manual page 49

.
A B C E F
Move the transmitter to within
10 ft of the FA400 Receiver, then
retest the wireless transmitter.
•
•
There is noise on the zonex data wiring.
Refer to
page 102.
Reprogram the transmitter as a new
transmitter.
Do not reconfigure the transmitter as an
existing transmitter.
You might need to perform this procedure
on more than one transmitter.
On the D8125INV:
1. Enter the passcode, then press [ENT].
2. Press [DIAG].
3. Press [1].
4. Enter the number of a wireless point that is in
trouble, then press [ENT].
5. Refer to Items 1 and 2 in
and refer to Table 27
Does the D8125INV indicate "This RF Point is not
programmed"?
Move the transmitter to within 10 ft. of the
FA400 Receiver, then retest the wireless
transmitter. Refer to Item 2 in
page 52, and refer to
Do the values match the condition of the
wireless transmitter?
A G H J
Bosch Security Systems, Inc. | 11/05 | F01U011024B
D9412GV2/D7412GV2 | Troubleshooting Guide | 3.0 Troubleshooting
If the values still do not match
the conditions of the wireless
transmitter, remove the
battery from the old
transmitter, and install a new
transmitter.
If the values now match the
conditions of the wireless
transmitter, then either
relocate the transmitter,
relocate the receiver, or add
an FA570 Repeater to the
system.
After reconfiguring a wireless
system, always retest the
system to ensure all devices
operate correctly.
TTP48 Noise on Wire on
Figure 27 on page 52,
on page 52.
Figure 27 on
Table 27 on page 52.
A G H J
Replace the battery in the wireless
transmitter, then retest the transmitter.
Do the values match the condition of
the wireless transmitter?
Reprogram the wireless
transmitter, then retest the
transmitter.
•
•
Problem is corrected.
Either relocate the transmitter, relocate the
receiver, or add an FA570 Repeater to the
system.
After reconfiguring a wireless system,
always retest the system to ensure all
devices operate correctly.
Reprogram the transmitter as a new transmitter.
Do not reconfigure the transmitter as an existing
transmitter.
You might need to perform this procedure on
more than one transmitter.
On the D8125INV:
1. Enter the passcode, then press [ENT].
2. Press [DIAG].
3. Press [1].
4. Enter the number of a wireless point that is in trouble,
then press [ENT].
5. Refer to Item 1 and Item 2 in
and refer to Table 27 on page 52.
Does the D8125INV indicate "This RF Point is not
programmed"?
Does item 2 in Figure 27
"Missing"?
Refer to Figure 28
Is the control panel wired to the D8125INV
correctly?
K L M N
If the values now match
the condition of the
transmitter, then the
problem is corrected.
If the values still do not
match the condition of the
transmitter, remove the
battery from the
transmitter and replace
the transmitter.
Figure 27 on page 52,
indicate "Bad" or
on page 54.
49