Bosch D9412GV2 Troubleshooting Manual page 125

.
4.3.3 Receiving Control Panel Programming Using
the D5200 Programmer
1. Connect the programming cord to the
Communicator port on the D5200, and to the
four-pin programming jack marked PROG on
the control panel.
2. Press [ON] to turn on the D5200.
3. If necessary, enter the correct password and
press [ENTER].
4.
Highlight the handler by pressing [↑] or [↓], then
press [ENTER GROUP].
In this example, the 9000MAIN handler is
highlighted.
5. Select N EWRECORD and press the red [RECV
(COPY)] key to copy the handler from the
control panel.
6. When D5200 receives the record, the top line
changes to RECEIVE SUCCESSFUL.
Bosch Security Systems, Inc. | 11/05 | F01U011024B
D9412GV2/D7412GV2 | Troubleshooting Guide | 4.0 Appendix
4.3.4 Sending Programming Changes to the
Control Panel Using the D5200 Programmer
1. Press the [SEND (LOAD)] key.
2. When the record is sent, the top line changes to
SEND SUCCESSFUL.
You can press the [SEND (LOAD)] key on
the D5200 Programmer at any time.
3. Reboot the control panel to synchronize the
numeric keys.
125