Bosch D9412GV2 Troubleshooting Manual page 82

D9412GV2/D7412GV2 | Troubleshooting Guide | 3.0
Table 47: D9133TTL-E Ethernet Status LED Function
LED Description
1 Serial Port (Channel) 1
Status
2 Serial Port (Channel) 2
Status
3 Diagnostic
4 Network Link Status
* Non-fatal error
The network interface module (NIM) software version must be version 4.5 or above. To verify the
software version, initiate a Telnet session. Refer to
82
Troubleshooting
Function
NIM Software Version 4.5: On to indicate Serial Port (Channel) 1 is idle.
NIM software version 5.1b5 or 5.1b6: Off to indicate Serial Port (Channel) 1 is idle.
Not used.
Disregard status.
Glows steadily or flashes red in combination with the Channel 1 LED to indicate
diagnostics and error detection.
LED 3 solid red, LED 1 (Channel 1) flashing red:
1x EPROM checksum error
2x RAM error
3x Network controller error
LED 3 flashing red, LED 1 (Channel 1) flashing red:
4x Faulted network connection*
On to indicate the network port is connected to the network.
Using Telnet for Configuration
Bosch Security Systems, Inc. | 11/05 | F01U011024B
4x EEPROM checksum error
5x Duplicated IP address on the network*
6x Software does not match hardware
5x
No DHCP response received
on page 86.
*