Installing and Removing Cards
2
Hold the card (or set of cards) so that the components are facing
upward and the main connector is pointing away from you.
3 Align the card (or set of cards) with an appropriate set of slots on the
I
rear panel, filling the slots closest to the bottom first. Gently slide the
card in until the connector on the card touches the connector on the
frame.
Installing Cards
"°
.0·1~·
0
•
0
--~.Ill
16530E34
4 Gently, but firmly, push the card in until the endplate on the card is
flush with the rear panel.
5 While applying pressure to the center of the card endplate, tighten
down the thumb screws on either side of the endplate.
6
After you are finished installing cards, install filler panels in all
unused slots.
13-5