HP 16550A User Reference page 21

I
Probing
This chapter contains a description of the probing system for the logic
analyzer. It also contains the information you need for connecting the
probe system components to each other, to the logic analyzer, and to
the system under test.
Probing Options
You can connect the logic analyzer to your system under test in one of
the following ways:
• HP 10320C User-Definable Interface (optional).
• Microprocessor and bus specific interfaces (optional).
• The standard general purpose probing (provided).
• Direct connection to a 20-pin, 3M-Series type header connector
using the optional termination adapter.
The HP 10320C User-Definable Interface
The optional HP 10320C User-Definable Interface module combined
with the optional HP 10269C General Purpose Probe Interface allows
you to connect the logic analyzer to the microprocessor in your target
system. The HP 10320C includes a breadboard which you custom
wire for your system.
Another option for use with the HP 10320C is the HP 10321A
Microprocessor Interface Kit. This kit includes sockets, bypass
capacitors and a fuse for power distribution. Also included are
wire-wrap headers to simplify wiring of your interface when you need
active devices to support the connection requirements of your system.
You will find additional information about the HP 10320C and the HP
10321A in the Accessories for HP Logic Analyzers .
2-2