HP 16550A User Reference page 24

Probing
Preprocessor File Configuration Translation and Pod Connections
I
Preprocessor configuration files from an HP 16510B, HP 16511B, and
HP 16540A,D can be used by the HP 16550A logic analyzer. However,
some pods must be connected differently in order for the
configuration files (version 5.0 or later) to work properly. The table
below and on the next page gives information on what configuration
files to load and the required connecting order between the pods in
the old configuration and the new HP 16550A pods.
At the end of the table there are definitions of the terms used in the
table and any notes found in the table.
Software and Hardware Translation Information
Preprocessor Target Recommended Old Pods to New Pods Old Pods to New Pods in a
Number Microprocessor Configuration in a One Card Module Two Card Module
File to Transfer
103140 80386DX 165108 No Changes Required
N/A
E24098 80286 Factory
N/A N/A
103058
8086/88
165108 1,2,3 to 3, 1,2
N/A
E2426A/8 68020/EC020 165108 or No Change Required
N/A
Factory
E2423A SCSl-2
165108 No Change Required N/A
103118
68000/10
165108 No Change Required
N/A
10311 G
68000/10 165108 No Change Required N/A
10316G 68030
165108 or No Change Required N/A
Factory
E2403A
80486 Factory N/A N/A
E2401A R3000 16540A,D No Change Required 1,2,3,4,5,6, 7 to
M1 ,M2,M3,M4,M5,M6,E1
E2420A
68040 16540A,D 1,2,3,4,5,6 to 1,2,5,6,3,4 1,2,3,4,5,6,7 to
M 1,M2,M5,M6,M3,M4,E1
2-5