Default Dial-In Filter; Dial-In Users Setup; Figure 6-4 Default Dial-In Filter - ZyXEL Communications Prestige 202 User Manual

Prestige 202 ISDN Router
FIELD
IP Count (1, 2)
Session Options:
Edit Filter Sets
Once you have completed filling in Menu 13
ENTER to Confirm ... ] to save your configuration, or press [Esc] at any time to cancel.

6.3.2 Default Dial-in Filter

Use Menu 13.1 – Default Dial-in Filter
outgoing traffic between all dial-in users and your Prestige. Note that the filter set(s) only applies to
the dial-in users but not the remote nodes. You can specify up to 4 filter sets separated by comma,
e.g., 1, 5, 9, 12, in each filter field. The default is no filters.
Spaces are accepted in this field. For more information on defining the filters, see Chapter 9.
6.4

Dial-In Users Setup

The following steps describe the setup procedure for setting up a remote dial-in user.
From the Main Menu, enter 14 to go to Menu 14 – Dial-in User Setup, as shown in the
Step 1.
next figure.
6-6
DESCRIPTION
192.68.135.5 and 192.68.135.6. The IP count is the
number of consecutive IP addresses allowed.
Select Yes, then press [Enter] to edit the filter sets. Keep
in mind that the filter set(s) will only apply to remote dial-
in users but not the remote nodes.
–
NOTE: Spaces and [
For more information on customizing your filter sets, see
–
Chapter 9 Filter Configuration. The default is blank,
i.e., no filters.
–
Default Dial-in Setup, press [Enter] at the message [Press
to specify the filter set(s) to apply to the incoming and
Menu 13.1 - Default Dial-in Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Press ENTER to Confirm or ESC to Cancel:

Figure 6-4 Default Dial-in Filter

] symbol are accepted in this field.
OPTIONS
1, 2
No (default)
Dial-in Server Configuration