Figure 8-4 Default Dial-In Filter; Dial-In Users Setup - ZyXEL Communications Prestige 480 User Manual

Prestige 480 Dual BRI ISDN Router
8.3.1 Default Dial-in Filter
Move cursor to the field Edit Filter Sets in Menu 13, press space bar to toggle and set the value to
Yes and then press [Enter] to open Menu 13.1 – Default Dial-in Filter.
Use this menu to specify the filter set(s) to apply to the incoming and outgoing traffic between all dial-in
users and your Prestige. Note that the filter set(s) only applies to the dial-in users but not the remote nodes.
You can specify up to 4 filter sets separated by comma, e.g., 1, 5, 9, 12, in each filter field. The default is no
filters.
Spaces are accepted in this field. For more information on defining the filters, see Chapter 9.
8.4

Dial-In Users Setup

The following steps describe the setup procedure for setting up a remote dial-in application.
Step 1. From the Main Menu, enter option 14 to go to Menu 14 - Dial -in User Setup, as shown in the
next figure.
Dial-In Server Configuration
Menu 13.1 - Default Dial -in Filter
Input Filter Sets:
protocol filters=
device filters=

Figure 8-4 Default Dial-in Filter

8-7