Dial-In Users Setup; Figure 8-4 Default Dial-In Filter - ZyXEL Communications Prestige 128 Plus User Manual

Prestige 128+ ISDN Router
8.3.1 Default Dial-in Filter
Use Menu 13.1 – Default Dial-in Filter
incoming and outgoing traffic between all dial-in users and your Prestige. Note
that the filter set(s) only applies to the dial-in users but not the remote nodes.
You can specify up to 4 filter sets separated by comma, e.g., 1, 5, 9, 12, in each
filter field. The default is no filters.
Spaces are accepted in this field. For more information on defining the filters,
see Chapter 9.
8.4

Dial-In Users Setup

The following steps describe the setup procedure for setting up a remote dial-in
user.
From the Main Menu, enter option 14 to go to Menu 14 - Dial-in User
Step 1.
Setup, as shown in the figure below.
1. JohnDoe
2. ________
3. ________
4. ________
5. ________
6. ________
7. ________
8. ________
8-8
to specify the filter set(s) to apply to the
Menu 13.1 - Default Dial-in Filter
Input Filter Sets:
protocol filters=

Figure 8-4 Default Dial-in Filter

Menu 14 - Dial-in User Setup
Enter Menu Selection Number:
Dial-In Server Configuration