Housing; Power On Your Prestige - ZyXEL Communications Prestige 202 User Manual

Prestige 202 ISDN Router
2. A computer equipped with communications software configured to the following parameters:
♦ VT100 terminal emulation.
♦ 9600 Baud.
♦ No parity, 8 Data bits, 1 Stop bit, no Flow Control.
After the Prestige is properly set up, you can make future changes to the configuration through
telnet connections.
2.4

Housing

Your Prestige's housing has ventilation slots for cooling and clip-out legs that fit snugly into
grooves for sturdy stacking with better airflow. ZyXEL recommends that you do not stack more
than 4 routers for maximum stack stability and cooling.
2.5

Power On Your Prestige

At this point, you should have connected the console port, the ISDN BRI port, the Ethernet port
and the power port to the appropriate devices or lines. You can now apply power to the Prestige by
flipping the power switch to the on position (I is ON, O is OFF).
Initial Screen
Step 1.
When you power on your Prestige, it performs several internal tests as well as line initialization.
After the initialization, the Prestige asks you to press [Enter] to continue, as shown.
Copyright (c) 1994 - 2000 ZyXEL Communications Corp.
initialize ch =0, ethernet address: 00:a0:c5:21:ce:67
(2) DSS1:
Press ENTER to continue...
2-4
Figure 2-3 Power-On Display for DSS1 Switch
Hardware Installation and Initial Setup