Table 6-2 Default Dial-In Setup Fields - ZyXEL Communications Prestige 202 User Manual

Prestige 202 ISDN Router
From the Main Menu, enter 13 to go to Menu 13 – Default Dial-in Setup. This section describes
how to configure the protocol-independent fields in this menu. For the protocol-dependent fields,
refer to the appropriate chapters.
The following table describes and contains information on how to configure each parameter in
Menu 13 – Default Dial-in Setup.
FIELD
Telco Options: CLID
Authen
PPP Options:
Recv Authen
Compression
Mutual Authen
O/G Username
6-4

Table 6-2 Default Dial-in Setup Fields

DESCRIPTION
This field sets the CLID authentication parameter for all
incoming calls. There are three options for this field:
l
–
None No CLID is required.
l
Required – CLID must be available, or the Prestige
will not answer the call.
l
–
Preferred If the CLID is available then CLID will
be used; otherwise, authentication is performed in
PPP negotiation.
This field sets the authentication protocol for incoming
calls. For security reason, setting authentication to None
is strongly discouraged. Options for this field are:
l
–
CHAP/PAP Your Prestige will try CHAP first, but
PAP will be used if CHAP is not available.
l
CHAP – Use CHAP only.
l
PAP – Use PAP only.
l
None – Your Prestige tries to acquire CHAP/PAP
first, but no authentication is required if CHAP/PAP
is not available.
Turn on/off Stac Compression. The default for this field
is No.
Some vendors, e.g., Cisco, require mutual
authentication, i.e., the node that initiates the call will
request a user name and password from the far end that
it is dialing to. If the remote node requires mutual
authentication, set this field to Yes.
Enter in the login name to be used to respond to the
peer's authentication request.
OPTIONS
None
Required
Preferred
CHAP/PAP
CHAP
PAP
None
Yes/No
Yes/No
Dial-in Server Configuration