Ethernet Setup; Figure 2-17 Isdn Advanced Setup; Figure 2-18 Loopback Test - ZyXEL Communications Prestige 202 User Manual

When you are finished, press [Enter] at the message: 'Press ENTER to confirm', the Prestige uses
the information that you entered to initialize the ISDN line. It should be noted that whenever the
switch type is changed, the ISDN initialization takes slightly longer.
At this point, the Prestige asks if you wish to test your ISDN. If you select Yes, the Prestige will
perform a loop-back test to check the ISDN line. If the loop-back test fails, please note the error
message that you receive and take the appropriate troubleshooting action.
Setup LoopBack Test ...
Dialing to 40000// ...
Sending and Receiving Data ...
Disconnecting ...
LoopBack Test OK
### Hit any key to continue. ###

2.13 Ethernet Setup

This section describes how to configure the Ethernet using Menu 3 – Ethernet Setup. From the
Main Menu, enter 3 to open Menu 3.
Hardware Installation and Initial Setup
Menu 2.1 - ISDN Advanced Setup
Phone 1 Call Waiting= Enable
Phone 2 Call Waiting= Enable
Calling Line Indication= Enable
PABX Outside Line Prefix=
PABX Number (Include S/T Bus Number) for Loopback=
Outgoing Calling Party Number:
ISDN Data
A/B Adapter 1=
A/B Adapter 2=
Hangup Silence Time(sec)= 0
Data Link Connection= point-to-multipoint
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.

Figure 2-17 ISDN Advanced Setup

Figure 2-18 Loopback Test

=
Prestige 202 ISDN Router
2-25