11.2.2 Using the FTP command from the DOS Prompt
Step 1.
Launch the FTP client on your computer.
Step 2.
Enter "open" and the IP address of your Prestige.
Step 3.
Press [ENTER] when prompted for a username.
Step 4.
Enter "root" and your SMT password as requested. The default is 1234.
Step 5.
Enter "bin" to set transfer mode to binary.
Step 6.
Use "get" to transfer files from the Prestige to the computer, for example, "get rom-0
config.rom" transfers the configuration file on the Prestige to your computer and renames it
"config.rom". See earlier in this chapter for more information on filename conventions.
Step 7.
Enter "quit" to exit the ftp prompt.
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> get rom-0 zyxel.rom
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 327680 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit
The following table describes some of the commands that you may see in third party FTP clients.
Table 11-2 General Commands for Third Party FTP Clients
COMMAND
Host Address
Login Type
Transfer Type
Firmware and Configuration File Maintenance
Figure 11-2 FTP Session Example
Enter the address of the host server.
Anonymous.
This is when a user I.D. and password is automatically supplied to
the server for anonymous access. Anonymous logins will work only if
your ISP or service administrator has enabled this option.
Normal.
The server requires a unique User ID and Password to login.
Transfer files in either ASCII (plain text format) or in binary mode.
Prestige 650H-17 ADSL Router
DESCRIPTION
11-3