Show Ipv6Route; Enable Ipif_Ipv6_Link_Local_Auto - D-Link DGS-1210/ME series Reference Manual

DGS-1210-28P/ME:5# delete ipv6route default
Command: delete ipv6route default
Success.
DGS-1210-28P/ME:5#

show ipv6route

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To o show a static IPv6 entry from the routing table:
DGS-1210-28P/ME:5# show ipv6route
Command: show ipv6route
IPv6 Prefix: ::/0
Next Hop : 3ffc::1
Total Entries: 1 DGS-1210-28P/ME:5#

enable ipif_ipv6_link_local_auto

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the IP interface IPv6 link-local settings on the switch:
DGS-1210-28P/ME:5# enable ipif_ipv6_link_local_auto System
Command: enable ipif_ipv6_link_local_auto System
Success.
DGS-1210-28P/ME:5#
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
Used to display a static IPv6 route entry from the Switch's IP routing
table.
show ipv6route
This delete ipv6route command will display an existing static IPv6
entry from the Switch's IP routing table.
None.
None.
Used to enable the autoconfiguration of the link local address when
no IPv6 address is configured.
enable ipif_ipv6_link_local_auto <ipif_name 12>
This enable ipif_ipv6_link_local_auto command will automatically
create an IPv6 link local address for the Switch if no IPv6 address
has previously been configured.
<ipif_name 12> - Specifies the name.
Only Administrator or operator-level users can issue this command.
Protocol: Static Metric: 1
IPIF : System
367