Enable Admin - D-Link DGS-1210/ME series Reference Manual

Syntax
Description
Parameters
Restrictions
Example usage:
To view authenticaion server hosts currently set on the Switch:
DGS-1210-28P/ME:5# show authen server_group dlinkgroup
Command: show authen server_group dlinkgroup
(1) Group Name: dlinkgroup
(No servers in this group)
Total Entries : 1
DGS-1210-28P/ME:5#

enable admin

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable administrator privileges on the Switch:
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
show authen server_group {<string 15>}
The show authen server_ group command displays user-defined
authentication server groups previously created on the Switch.
The following parameters are displayed:
Group Name – The name of the server group.
IP Address – The IP address of the authentication server group.
Protocol – The protocol used by the server group. Possible results
include TACACS+ or RADIUS.
None.
Only Administrator-level users can issue this command.
To promote user level privileges to administrator level privileges.
enable admin
The enable admin command enables a user to be granted
administrative privileges on to the Switch. After logging on to the
Switch, users have only 'user' level privileges. To gain access to
administrator level privileges, the user may enter this command. The
system then prompts for an authentication password. Possible
authentication methods for this function include TACACS,
TACACS+, RADIUS, user defined server groups, local enable (local
account on the Switch), or no authentication (none). Because
TACACS does not support the enable function, the user must create
a special account on the server host which has the username
'enable', and a password configured by the administrator that will
support the 'enable' function. This function becomes inoperable
when the authentication policy is disabled.
None.
Only administrator-level users can issue this command.
DGS-1210-28P/ME:5# enable admin
Command: enable admin
402