Show Serial_Port; Config Serial_Port - D-Link DGS-1210/ME series Reference Manual

Restrictions
Example usage:
To show the jumbo_frames configuration status on the device:

show serial_port

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the serial port settings:

config serial_port

Purpose
Syntax
Description
Parameters
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
None.
DGS-1210-28/ME:5# show jumbo_frame
Command: show jumbo_frame
Jumbo Frame is Enabled.
DES-1210-52/ME:5#
Used to display the current serial port settings.
show serial_port
The show serial_port command displays the current serial port
settings.
None.
None.
DGS-1210-28P/ME:5# show serial_port
Command: show serial_port
Baud Rate : 9600
Data Bits : 8
Parity Bits : None
Stop Bits : 1
Auto-Logout : 10 minutes
DGS-1210-28P/ME:5#
Used to configure the serial port.
config serial_port {baud_rate [9600 | 19200 | 38400 | 115200] |
auto_logout [never | 2_minutes | 5_minutes | 10_minutes |
15_minutes]}
The config serial_port command is used to configure the serial
port's baud rate and auto logout settings.
baud_rate [9600 | 19200 | 38400 | 115200] − The serial bit rate that
will be used to communicate with the management host. There are
four options: 9600, 19200, 38400 and 115200. Factory default
setting is 115200.
never − No time limit on the length of time the console can be open
with no user input.
2_minutes − The console will log out the current user if there is no
user input for 2 minutes.
18