Web-Based Access Control Commands; Enable Wac - D-Link DGS-1210/ME series Reference Manual

WEB-BASED ACCESS CONTROL COMMANDS

The Web-Based Access Control commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command

enable wac

disable wac
config wac
default_redirpath
config wac method
config wac ports
config wac
switch_http_port
config wac virtual_ip
create wac user
delete wac user
show wac user
show wac
show wac ports
show wac auth_state
ports
Each command is listed in detail, as follows:
enable wac
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the WAC function:
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
Parameter
<string 20>
{radius | local}
[<portlist> | all] [state [enable | disable] | aging_time [infinite | <min 1-1440>] |
block_time <sec 0-300>]
<tcp_port_number 1-65535> {https}
[<ipaddr> | <ipv6addr>]
<username 15> vlanid <vlanid 1-4094> password <passwd 16>
<username 15>
[all | <portlist>]
[all | <portlist>]
To enable the WAC function.
enable wac
The enable wac command is used to enable the WAC function.
None.
Only administrator or operator-level users can issue this command.
DGS-1210-28P/ME:5# enable wac
Command: enable wac
246
32