Enable Mac_Based_Access_Control; Disable Mac_Based_Access_Control; Config Mac_Based_Access_Control Password - D-Link DGS-1210/ME series Reference Manual

enable mac_based_access_control

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable MAC-based AC function:
DGS-1210-28P/ME:5# enable mac_based_access_control
Command: enable mac_based_access_control
Success.
DGS-1210-28P/ME:5#

disable mac_based_access_control

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable MAC-based AC function:
DGS-1210-28P/ME:5# disable mac_based_access_control
Command: disable mac_based_access_control
Success.
DGS-1210-28P/ME:5#

config mac_based_access_control password

Purpose
Syntax
Description
Parameters
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
To enable MAC-based Access Control.
enable mac_based_access_control
The enable mac_based_access_control command will enable the
MAC-based AC function.
None.
Only administrator or operator-level users can issue this command.
To disable MAC-based Access Control.
disable mac_based_access_control
The disable mac_based_access_control command will disable
the MAC-based AC function.
None.
Only administrator or operator-level users can issue this command.
To configure the password of the MAC-based Access Control.
config mac_based_access_control password <passwd 16>
The config mac_based_access_control password command will
set the password that will be used for authentication via RADIUS
server.
<passwd 16> - In RADIUS mode, the Switch communicate with
RADIUS server use the password. The maximum length of the key
239