World Wide Node Name Configuration - HP M2402 User Manual

Note:
options from the menu bar on the left side of the screen or select a module or port from
the router image at the top of the screen. To make changes, modify the setting and then
click Submit.
Modules Menu tasks:
Each Modules Menu option is discussed in the following sub-sections.

World Wide Node Name Configuration

The World Wide Node (WWN) Name screen is used to change the WWN Name
settings for the router.
Figure 42
These WWN settings are not normally changed.
Note:
be compliant with IEEE Fibre Channel Format 1, where the left-most hexadecimal
character (the NAA field) of the WWN is '1'. Further, the sixth hexadecimal value from
the right must be a value of '0' or'1'.
Note:
WWN settings will be overwritten.
Network Storage Router M2402 User Guide
To view or change configuration settings of a specific module, select one of the
World Wide Node Name configuration changes World Wide Node Name.
Fibre Channel Module configuration changes Fibre Channel module
settings.
SCSI Module configuration changes SCSI module settings.
is an example of the World Wide Node Name screen.
Caution: Changing the WWN Name could result in duplicate names on a
single Storage Area Network (SAN). HP recommends using the default values
for World Wide Names.
For Controller LUN commands to be operational, WWN naming schemes MUST
If the configuration settings are reset to the factory default, these customized
Visual Manager User Interface
67