Changing The Name Of The Current Map; Editing The Map Entries Of The Current Map - HP M2402 User Manual

Changing the Name of the Current Map

To change the name of the current map, in the Map Edit Menu, select Edit Name
(1). Then, enter the new name at the prompt.
Note:

Editing the Map Entries of the Current Map

To edit the details of the Current map, in the Map Edit Menu, select Edit Map
Entries (2). This editing screen allows the user to navigate up and down the map
entries and create or remove entries. Device lists are also available to make it
easier to identify the device to be mapped.
Note:
to create entries is protocol/port dependent.
Although the options are the same for editing maps of Fibre Channel and SCSI
modules, the screen display differs.
Figure 82
an example screen display for a SCSI map.
Network Storage Router M2402 User Guide
Only user-defined map names can be changed.
Mapping a device to its native port/bus is not allowed. The information needed
is an example screen display for Fibre Channel maps and
Serial/Telnet User Interface
Figure 83 is
135