Installing An I/O Module Or Blank Module - HP M2402 User Manual

Installing an I/O Module or Blank Module

To install an I/O module:
1. If an I/O module or blank module has not been removed, see the preceding
2. Remove power to the router.
3. Remove the new I/O module from its shipping container and remove all
Figure 128
module.
Figure 128: Thumbscrews and handle on a SCSI module
Network Storage Router M2402 User Guide
procedure, "Removing an I/O Module or Blank Module." When completed,
proceed to Step 2.
packing material from around the module.
Caution: Place the module onto a smooth surface and avoid exposure to
direct sunlight, liquids or vapors, excessive heat, or risk of accidental dropping
or other damage.
illustrates a SCSI module and
Hardware Module Replacement
Figure 129 illustrates a Fibre Channel
1
2
193