Modifications; Cables; Power Cords; Mouse Compliance Statement - HP M2402 User Manual

Regulatory Compliance Notices

Modifications

The FCC requires the user to be notified that any changes or modifications made
to this device that are not expressly approved by Hewlett-Packard Computer
Corporation may void the user's authority to operate the equipment.

Cables

Connections to this device must be made with shielded cables with metallic
RFI/EMI connector hoods in order to maintain compliance with FCC Rules and
Regulations.

Power Cords

The power cord set included in your server meets the requirements for use in the
country where you purchased your server. If you need to use this server in another
country, you should purchase a power cord that is approved for use in that country.
The power cord must be rated for the product and for the voltage and current
marked on the product's electrical ratings label. The voltage and current rating of
the cord should be greater than the voltage and current rating marked on the
product. In addition, the cross sectional area of the wire must be a minimum of
1.00 mm² or 18AWG, and the length of the cord must be between 6 feet (1.8 m)
and 12 feet (3.6 m). If you have questions about the type of power cord to use,
contact your HP authorized service provider.
A power cord should be routed so that it is not likely to be walked on or pinched
by items placed upon it or against it. Particular attention should be paid to the
plug, electrical outlet, and the point where the cord exits from the product.

Mouse Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
244 Network Storage Router M2402 User Guide