Table of Contents
Advertisement
Getting Started Guide for Branch SRX Series
Example: Configuring Destination NAT for SRX Series
Requirements
Overview
40
Connecting Your Branch SRX Series for the First Time
Example: Configuring Destination NAT for SRX Series on page 40
Before you can get access to your internal network from the outside, you need to configure
destination NAT. In this example, you are applying destination NAT to allow connections
from the Internet to a private network (in the DMZ zone) after translating the public IP
address to the private address.
Before you begin, create security zones and assign interfaces to them. See
Configuring Security Zones and Policies for SRX Series" on page
This example uses the following hardware and software components:
An SRX210
Junos OS Release 12.1X44-D10
Using the topology shown in
the traffic destined to 1.1.1.3 coming from the untrust zone. This traffic should be translated
into the private IP address of 192.168.2.2 as shown in
Figure 4 on page
41, you are applying destination NAT to
Table 10 on page
Copyright © 2016, Juniper Networks, Inc.
"Example:
32.
41.
Advertisement
Table of Contents
