Table of Contents
Advertisement
Output Fields
Table 16: show security policies Output Fields
Field Name
From zone
To zone
Policy
Description
State
Index
Sequence number
Source addresses
Destination addresses
Source addresses (excluded)
Destination addresses (excluded)
Source identities
Copyright © 2016, Juniper Networks, Inc.
Table 16 on page 121
lists the output fields for the
fields are listed in the approximate order in which they appear.
Field Description
Name of the source zone.
Name of the destination zone.
Name of the applicable policy.
Description of the applicable policy.
Status of the policy:
enabled
: The policy can be used in the policy lookup process, which determines access
rights for a packet and the action taken in regard to it.
disabled
: The policy cannot be used in the policy lookup process, and therefore it is
not available for access control.
Internal number associated with the policy.
Number of the policy within a given context. For example, three policies that are applicable
in a from-zoneA-to-zoneB context might be ordered with sequence numbers 1, 2, 3. Also,
in a from-zoneC-to-zoneD context, four policies might have sequence numbers 1, 2, 3,
4.
For standard display mode, the names of the source addresses for a policy. Address sets
are resolved to their individual names.
For detail display mode, the names and corresponding IP addresses of the source
addresses for a policy. Address sets are resolved to their individual address name-IP
address pairs.
Name of the destination address (or address set) as it was entered in the destination
zone's address book. A packet's destination address must match this value for the policy
to apply to it.
Name of the source address excluded from the policy.
Name of the destination address excluded from the policy.
One or more user roles specified for a policy.
Chapter 12: Operational Commands
command. Output
show security policies
121
Advertisement
Table of Contents
