Table of Contents
Advertisement
Getting Started Guide for Branch SRX Series
Related
Documentation
Mandatory Settings to Configure the Branch SRX Series
18
NOTE:
To access the device through SSH and Telnet, you need to set up
a root password. For more details, see Connecting Your Branch SRX Series
for the First Time.
Understanding Factory Default Configuration Settings of an SRX210 on page 7
Configuring a Hostname to Identify a Branch SRX Series Services Gateway in Your
Network on page 20
Table 6 on page 18
provides the details on configuration settings that you need to enter
when configuring the device for the first time.
Table 6: Settings Used to Configure the SRX210
Settings
Administrator Username
Administrator Password
Hostname
Network Time Protocol (NTP) Server
Time Zone
IP address assignment
Details
Record the login name of the services gateway
administrator. Default is root, which you must change
during your first J-Web session.
Record the password for this administrator account.
Record the name of your SRX210 to identify itself on
your network.
Network security often depends on knowing the exact
time, when a specific event occurs. If you do not have
access to a private NTP server, you can enter the name
or IP address of a public NTP server. For information
about public time servers, see
http://tf.nist.gov/tf-cgi/servers.cgi
Record the time zone to be used by your services
gateway.
Your Internet Service Provider might use the Dynamic
Host Configuration Protocol (DHCP) to assign an IP
address and routing information to your services
gateway.
NOTE:
The DHCP client configuration is by default
enabled on port
(ge-0/0/0).
0/0
NOTE:
If your ISP does not support DHCP, you should
ask your ISP what settings (IP address, default gateway,
DNS server) to use to configure the WAN interface on
your services gateway.
Copyright © 2016, Juniper Networks, Inc.
.
Advertisement
Table of Contents
