Managing Licenses For Srx Series; Updating Licenses For A Branch Srx Series - Juniper Junos OS Getting Started Manual

CHAPTER 7

Managing Licenses for SRX Series

Updating Licenses for a Branch SRX Series

Copyright © 2016, Juniper Networks, Inc.
Updating Licenses for a Branch SRX Series on page 47
You need to install a license for some of the advanced security features such as UTM
and IDP on a branch SRX Series.
Licensing is usually ordered when the device is purchased, and this information is bound
to the chassis serial number. These instructions assume that you already have the license.
If you have not ordered the licenses during the purchase of the device, contact your
account team or Juniper customer care for assistance.
For more information, refer to the Knowledge Base article KB9731 at
http://kb.juniper.net/KB9731
You can Install the license on the SRX Series using either the automatic method or manual
method as follows:
Install your license automatically on the device
To install or update your license automatically, your device must be connected to the
Internet .
user@srx210-host> request system license update
Trying to update license keys from https://ae1.juniper.net, use 'show system
license' to check status.
Install the licenses manually on the device.
user@srx210-host> request system license add terminal
[Type ^D at a new line to end input,
enter blank line between each license key]
Paste the license key and press Enter to continue.
To verify the license installed on your system, use the
shown in the following examples:
View license usage:
Licenses
Feature name
.
Licenses Licenses
used installed
show system license command
Expiry
needed
as
47