A - Specifications; Specifications - Agilent Technologies 66319B User Manual

Specifications

Specifications
Table A-1 lists the specifications of the dc source. Unless otherwise noted, specifications are warranted
over the ambient temperature range of 0 to 55 °C. Specifications apply with typical cellular phone
capacitive loads from 0μF to 12,000μF. Sensing is at the rear terminals of the power supply after a 30-
minute warm-up period. Sense terminals are externally jumpered to their respective output terminals.
Parameter
Output Ratings
Programming Accuracy
(@ 25°C ±5°C)
DC Measurement Accuracy
(via GPIB or front panel meters with
respect to actual output @ 25°C ±5°C)
Ripple and Noise
(in the range of 20 Hz to 20 MHz with
outputs ungrounded or with either
terminal grounded)
Load Regulation
(change in output voltage or current
for any load change within ratings)
Line Regulation
(change in output voltage or current
for any line change within ratings)
Transient Response Time
(for the output voltage to recover to
within 20 mV of its final value)
1
Peak current for up to a 7 millisecond time period. Average current cannot exceed 3 A.
2
Peak current for up to a 1 millisecond time period. Average current cannot exceed 1.5 A.
3
0.05% +2.3mA when programming between zero and 0.03% of full scale current
4
Applies with current detector set to DC. ACDC mode accuracy is 0.2% + 3mA for sourcing and 0.2% + 3.6 mA for sinking.
5
Specification is for phone capacitance greater than 6μF.
6
With resistance set to zero ohms.
7
Following a 0.1 A to 1.5 A load change in the HRemote compensation range.
8
Following a 0.75 A to 1.5 A load change.
Table A-1. Performance Specifications
Voltage:
Current:
Peak Current:
Voltage:
+Current:
Resistance:
Voltage:
Output 2 Current:
3 A Current range
−3 A to +5 A:
1 A Current range
−1 A to +1A:
0.02A Current range
−20 mA to +20 mA:
Voltage (rms/p-p):
Current (rms):
Voltage:
Current:
Voltage:
Current:
Agilent 66321B/D;
Agilent 66319B/D
output 1 only
0 – 15 V
0 – 3 A
1
5 A
0.05% + 10 mV
3
0.05% + 1.33 mA
0.5% + 2 mΩ
0.03% + 5 mV
NA
4
0.2% + 0.5 mA
0.1% + 0.2 mA
0.1% + 2.5 μA
5
1 mV/6 mV
2 mA
6
5 mV
0.75 mA
0.5 mV
0.75 mA
< 20 μs
7
A
Agilent 66319B/D
output 2 only
0 – 12 V
0 – 1.5 A
2
2.5 A
0.2% + 40 mV
0.2% + 4.5 mA
NA
0.2% + 15 mV
0.2% + 3 mA
NA
NA
NA
5
1 mV/6 mV
2 mA
1.6 mV
0.375 mA
0.4 mV
0.25 mA
< 400 μs
8
137