Agilent Technologies 66319B User Manual page 129

Command Syntax TRIGger:SEQuence2:SLOPe:DVM<slope>
Parameters EITHer | POSitive | NEGative
*RST Value POSitive
Examples TRIG:SEQ2:SLOP:DVM POS
Query Syntax TRIGger:SEQuence2:SLOPe:DVM?
Returned Parameters <CRD>
Related Commands TRIG:SEQ2:LEV:DVM
TRIGger:SEQuence2:SLOPe:VOLTage
TRIGger:ACQuire:SLOPe:VOLTage
This command sets the slope of an internally triggered voltage measurement.
triggering occurs on the rising edge.
POSitive
NEGative triggering occurs on the falling edge.
EITHer triggering occurs on either edge.
Command Syntax TRIGger:SEQuence2:SLOPe:VOLTage<slope>
Parameters EITHer | POSitive | NEGative
*RST Value POSitive
Examples TRIG:SEQ2:SLOP:VOLT POS
Query Syntax TRIGger:SEQuence2:SLOPe:VOLTage?
Returned Parameters <CRD>
Related Commands TRIG:SEQ2:SLOP:CURR
TRIGger:SEQuence2:SOURce
TRIGger:ACQuire:SOURce
These commands select the trigger source for measurement triggers as follows:
GPIB device, *TRG, or <GET> (Group Execute Trigger)
BUS
INTernal trigger is generated internally when the measured waveform crosses the trigger
level with the selected slope.
EXTernal Selects the external trigger input on the 4-pin control connector as the trigger
source (only applies to units with firmware revision A.03.01 and up)
Command Syntax TRIGger:SEQuence2:SOURce<source>
Parameters BUS | INTernal
*RST Value INTernal
Examples TRIG:ACQ:SOUR BUS
Query Syntax TRIGger:SEQuence2:SOURce?
Returned Parameters <CRD>
TRIGger:ACQuire:SLOPe:DVM<slope>
TRIGger:ACQuire:SLOPe:DVM?
TRIGger:ACQuire:SLOPe:VOLTage<slope>
TRIGger:ACQuire:SLOPe:VOLTage?
TRIGger:ACQuire:SOURce<source>
TRIGger:ACQuire:SOURce?
Language Dictionary - 8
TRIG:ACQ:SLOP:DVM EITH
TRIG:ACQ:SLOP:VOLT EITH
129