Buell 2008 XB SERIES Electrical Diagnostics Manual page 184

Side Stand Sensor Low: DTC P1501 (45); Side Stand Sensor High: DTC P1502 (45); Side
Stand Sensor Down at Vehicle Speed: DTC P1503 (45) (Part 3 of 3)
Inspect the Side Stand tab for correct
clearance to Side Stand sensor 0.18 inches
Is the sensor mounted correctly?
YES
Turn on ignition switch and
check voltage on Side Stand
sensor connector [133B]
terminal "4".
Is 5V present?
YES
Turn off ignition switch and check for
Replace
continuity between switch connector
Side Stand
Sensor.
connector [11B] (Gray) terminal "25".
Replace
ECM.
2-134 2008 Buell XB Diagnostics: Engine Management
Continued from Side Stand Sensor Test, DTC P1501
(45); P1502 (45); P1503 (45) (Part 1 of 3).
Clear DTC 1501 and/or DTC 1502 before proceeding.
Are the Side Stand and associated parts in good
YES
(4.5mm) maximum.
NO
Make adjustments in
accordance with the
appropriate Buell
Service Manual and
retest.
NO
[133B] terminal "1" and ECM
Is continuity present?
YES NO
Repair
open wire.
operating condition?
Is the Side Stand in good
YES
Is Side Stand mounted
correctly?
YES
Check spring for proper
tension.
Does spring have correct
tension?
YES
Operation normal.
NO
Inspect the Side Stand.
mechanical condition?
NO
Replace Side
Stand.
NO
Install Side Stand in
accordance with the
appropriate Buell Service
Manual.
NO
Replace spring.
fc01632_en