Buell 2008 XB SERIES Electrical Diagnostics Manual page 148

Start System Relay: DTC P0617 (46) (Part 2 of 2)
Check neutral connector [131] for
proper mating to neutral switch.
Is connector [131] mated properly?
YES
Replace
neutral switch.
2-98 2008 Buell XB Diagnostics: Engine Management
Continued from Start System Relay Test, DTC
P0616 (46), P0617 (46) (Part 1 of 2).
Does starter rotate when start switch is pressed?
YES
Replace
NEUTRAL
lamp in IM.
YES
Check for continuity between
ECM connector [11B] (Gray)
terminal "8" (TN/Y) and ground.
Is continuity present?
YES
Locate and repair
open wire (TN/Y)
and retest.
NO
Mate connectors
and retest.
NO
Does starter rotate when
clutch is disengaged and
start switch is pressed?
Check for continuity between ECM connector
[10B] (Black) terminal "7" (GN/O) and start
relay connector [62B] terminal "2" (GN/O).
NO YES
With the ignition switch
ON, check voltage on
connector [10B] (Black)
terminal "8" to ground.
Is voltage 0.6V or less?
YES
Replace Start
Relay.
NO
Is continuity present?
NO
Locate and repair
open wire (GN/O)
and retest.
NO
Replace ECM.
fc01636_en