Table of Contents
Advertisement
Client IP address
Enter here any unused IP address of the local network related to the VPN
connection.
Factory settings
The factory settings for the SINAUT MD741-1 are as follows:
Enable VPN supervision
Interval for connection check (minutes)
Waiting time before repetition (minutes)
Number of unsuccessful connection checks
up to restarting the VPN client
7.7
Advanced settings for VPN connections
Setting special timeouts and intervals for VPN connections.
Figure 7-12
Keepalive interval for NAT-T (seconds)
If NAT-T is enabled, then keepalive data packets will be sent periodically by the
SINAUT MD741-1 through the VPN connection. The purpose of this is to prevent a
NAT router between the SINAUT MD741-1 and the remote station from interrupting
the connection during idle periods without data traffic.
Here you can change the interval between the keepalive data packets.
SINAUT MD741-1
C79000-G8976-C236-05
IPsec VPN > Advanced Settings
7 VPN connection
Nein
5
1
3
103
Advertisement
Table of Contents
