Figure 4-20
4.4.8
UPNP
Important
Do not connect the switch to the PoE port, otherwise the connection may fail!
Please connect the IPC to the PoE port of the device rear panel (Figure 4-21), system can auto connect
to the network camera. Please note the following figure is for reference only.
Figure 4-21
4.4.9
Built-in Switch Setup
The built-in switch function is for product of PoE port.
From Main menu->SETTING->NETWORK->SWITCH, you can set switch IP address, subnet mask,
gateway and etc. See Figure 4-22.
38